(You could also use 680 ohms and 1k or 68k and 100k to get the same division ratio depending on drive level requirements). eg 6k8 from 5V output to 3v3 input and 10k from 3v3 input to ground will provide the required division. eg if you use a 5V supply you divide by 3/5 = 0.6. You can opertae it from 4.5V or above as an "astable oscillator" and divide the output voltage down to 3.3V logic levels. The actual step carried out will depend on the option settings.Īn NE555 will not operate on less than 4.5V. The motor will step once for each rising edge of the stepping signal. As shown on page 1, to operate the stepper you place reset high, enable low, set the direction line as required and then place a square wave on the "step" line. It is not apparent why you think you need to operate the driver at 3.3V logic levels, as tge stepper motor supply for this driver has an allowable range of 8 to 35 Volt, and the logic supply from 3.0 to 5.5 V, but I will assume that you do need to use the levels that you say.Ī4983 datasheet shows that to operate Reset = high, Enable = low. The user will need to select direction of rotation, which of the 4 connected drives is active and which of the various provided stepping modes is used.ĭigikey pricing page - in stock at $US4.97/1
A device like a 555 timer can easily be setup to control the stepping speed. Specifically designed to drive any one of 4 stepper motors at one time using a simple square wave signal as the step speed control. You could also use any other source of an appropriate level square wave to drive the stepping line, as described below. But if you are not using a microcontroller at all then the 555 will allow stepping job by itself. if you wanted something that you could "set and forget" without involving the mcu you could use a 555 or similar as well and just enable/disable it with the mcu, but this would not be a common choice.
That is, it is not hard to generate a square wave signal as part of an mcu's tasks.
If you are using a microcontroller (mcu) it is probably not necessary to use an eg 555 as well. Direction can be changed with a switch and stepping enabled/disabled by stipping the oscillator feed to the controller. The motor will then drive at one step (or microstep depending on option settings) per oscillator cycle. While the Quadstepper board that you refer to is probably intended by its makers to be driven with a microcontroller you can drive it, or the A4983 IC that it uses using a 555 timer or similar square wave oscillator plus a few switches or jumpers to set options and control lines. Driving that controller board with a 555 is "easy" - just apply a swuare wave to the step input while setting all other inputs high and low as appropriate.īUT if there is also a microcontroller present then no 555 is strictly necessary - consider just using that.
0 kommentar(er)
